Hettich ROTOFIX 32 A Mode D'emploi page 60

Commissioning
5.3 Setting up and connecting the centrifuge
Setting up the centrifuge
18 / 39
1
2
3
Fig. 14: Transport lock
1 Transport lock
2 Spacer sleeves
3 Screws
1. Tilt the device on the back of the device.
2. Unscrew 3 screws (
3. Remove 3 transport locks (
4. Keep the screws, spacer sleeves and transport lock in a safe place.
WARNING
Risk of injury due to failing to maintain a sufficient distance to
the centrifuge.
−
As per EN / IEC 61010-2-020, no persons, hazardous
materials or objects may be present within a safety zone
of 300 mm around the centrifuge during a centrifugation
run.
−
A distance of 300 mm from the ventilation slots and ven-
tilation openings of the centrifuge must be maintained.
CAUTION
Risk of crushing and damage to the device due to it falling
down because of vibration-induced position alterations.
−
Place the device on a stable and level surface.
−
Select the installation surface dependent on the weight
of the device.
Rev.: 17 / 01.2024
2
2
3 ) with spacer sleeves ( 2 ).
1 ) and store them safely.
3
2 3
AB1206en
1