Hettich ROTOFIX 32 A Mode D'emploi page 63

4
Fig. 15: Rotor installation and
removal
1 Groove
2 Motor shaft
3 Driver
4 Hole
Installing the rotor with a
clamping nut
Removing the rotor without a
clamping nut
Removing the rotor
Fig. 16: Rotor installation and
removal
1 Rotary handle
2 Hub
AB1206en
1. Open the lid.
2. Loosen the rotor clamping nut using the supplied spanner.
�� After passing the working point for lifting the rotor, the rotor
detaches from the cone of the motor shaft (
1
3. Turn the clamping nut until the rotor can be lifted off the motor shaft.
4. Remove the rotor.
2
3
Personnel:
■
Trained user
The lid is open.
1. Clean the motor shaft (
2. Lightly grease the motor shaft (
cleaning and disinfection' on page 31 .
3. Place the rotor vertically on the motor shaft (
3 ) of the motor shaft must be in the groove ( 1 ) of the
The driver (
rotor. The orientation of the groove is marked on the rotor.
4. Hand-tighten the rotor clamping nut using the supplied spanner.
5. Check that the rotor is firmly seated.
Personnel:
■
Trained user
Hold the rotor by the rotary handle (
1
2 ).
(
2
Rev.: 17 / 01.2024
2 ).
2 ) and rotor hole ( 4 ).
2 ), see ⮫ Chapter 8.2 'Instructions for
2 ).
1 ) of the lid and lift it off the hub
Operation
21 / 39