Lightingtheburners
Everyone who operates the appliance must be familiar with the lighting procedure. Children or
persons with reduced mobility must not be allowed to operate the grill. Never bend over the open
grill.
Always keep at least 30 cm away from the source of ignition when lighting the grill.
Keep your face, hair, beard, loose and flowing clothing, etc., well clear.
LightingprocedureformainburnerswiththeJetFlameignitionsys-
tem
1. Before starting the lighting procedure, all control knobs must be set to the
position "•" OFF.
2. Open the lid of the grill before you light the main burners.
3. Open the gas cylinder valve by turning anticlockwise (at least two full turns).
4. Check all gas connections for leaks. See section "Leak check".
5. Press the desired control knob inwards and turn it slowly anticlockwise to the "MAX" position or until
you hear the click of the Jet Flame ignition system.
6. Hold down the control knob after the "click" for approx. 2 seconds so that the flame of the Jet Flame
can light the burner.
7.
It is possible to visually check the ignition system. Look at the Jet Flame ignition area at the side from a
distance. After the ignition spark was triggered by the control knob, the gas flowing past is ignited and
a pilot flame is produced which lights the main burner.
8. If the burner does not light immediately, turn the control knob back to "•" OFF and wait 2 minutes to
allow the accumulated gas to disperse. Now you can repeat the ignition procedure.
9. When the main burner has been lit, repeat this process until all the burners are lit or until you have lit
all the burners you wish to use.
10. You can now use the control knob to adjust the flame to suit your particular requirements.
For the lowest setting, you turn the control knob anticlockwise to "MIN".
11. If you do not succeed in lighting the gas grill, refer to the section "Troubleshooting".
12. After use press in the control knob (gas valve) for the respective burner and turn it clockwise to the
position "•" OFF.
42