Publicité
Les langues disponibles
Les langues disponibles
If you follow these tips, your RÖSLE gas grill will give you many years of reliable service.
•
Each time before using the gas grill, check the gas grill for any leaks using a soapy solution or leak
detector spray.
•
The cooking surfaces (including burner cover) should be kept clean and dry after barbecuing, especially
after barbecuing with marinades. They contain salt and attack the surface.
•
You should rub a little oil into the surfaces of the grates after use.
•
Do not leave your grill outside unprotected. After the grill has fully cooled down, you should store it in
the appropriate RÖSLE carrying bag in a dry location. Do not store the grill beside road salt.
•
Do not store your grill when wet. Carefully dry it first.
•
Slight surface rusting can easily be removed with a cloth soaked in vinegar essence or with a commer-
cial rust remover. Observe the information of the cleaning agent manufacturer.
•
Check regularly that the screw fixings are tight and that the support feet are firmly attached.
Troubleshooting
Problem
Solution
Appliance does not
•
light, no flame,
•
burner fault
•
•
•
Grill does not
STOP, turn off the gas cylinder and turn all valves to "•" OFF.
DO NOT smoke.
function properly
•
•
•
•
•
•
No spark
•
•
Uneven burner
Have the burners been cleaned? – Clean the burners; remove all residues.
Do not allow any water or cleaner to get into the burner jets.
flame pattern
Flash flames occur
•
•
Food burns on the
Your grill temperature is too low. Wait a few minutes before turning the food so it has time
grate
to cook properly.
Check whether the shut-off valve of the gas cylinder is opened.
Make sure that there is enough gas in the cylinder.
Is there a kink in the gas hose? – Straighten out the hose.
Check whether sparks are jumping across from the electrode to the burner.
Is it possible to light the burner with a long match? – Check the ignition system!
Check all gas connections.
Wait 3 minutes to allow the accumulated gas to disperse and
then repeat the lighting procedure.
The burners are not properly fitted over the outlets:
Fit burners exactly over the outlets.
Gas pipe is blocked:
Remove the gas hose from the gas grill. Turn on the gas cylinder just for a second to
remove any blockage from the hose. Turn off the gas cylinder again after a second and
reconnect the gas hose to the gas grill.
Blocked outlets:
Remove the burners as described above. Check the gas valve outlets and use a thin metal
wire to remove any residues that might be causing a blockage. Place burner over the
outlets again and check whether the burner is now functioning properly.
Check the burner regularly in order to ensure that it is free of insects and spiders which
may block the gas system or impair the gas flow. Make sure that the Venturi tubes of the
burner are cleaned carefully so that there are no more obstacles. We recommend a tube
brush for cleaning the Venturi tubes.
The distance between the burner and the electrode should not be more than 5-8 mm.
If necessary, clean electrode and readjust it.
You may not have sufficiently preheated the grill. Preheat the grill for approx. 15
minutes with all burners lit.
Clean the grill grates, fat catcher tray, etc., so that all fat deposits are removed.
51
Publicité
