Zeiss VISULAS YAG III Mode D'emploi page 119

44
Operation
Aiming beam
Switch aiming beam on.
In Treatment STANDBY mode, the aiming beam is switched
on and off by touching this button. If the aiming beam is
on, this button appears in reverse colour.
Aiming beam intensity
After touching this button, the intensity of the aiming beam
can be adjusted by turning the control knob.
STANDBY/READY
Display and switch between STANDBY/READY
Touching this button switches the system into Treatment
READY mode after approximately three seconds. This
transition time is visually indicated by a blinking button.
Touching this button again returns the system to Treatment
STANDBY mode.
The key illustrated is the STANDBY key.
Note
If the system has been in Treatment STANDBY mode for
more than 30 minutes, on switching to Treatment READY
mode the system will release a series of internal laser shots in
order to update the energy values for each pulse mode.
Information mode
Touching the INFO button in Treatment STANDBY mode switches
the system into Information mode (Fig. 23).
Fig. 23 Information mode
000000-1354-664 VISULAS YAG III 15.08.2005