ResMed AirCurve 11 VAUTO Mode D'emploi page 17

Tube Temperature
1. Tap Tube Temp.
2. Tap the preferred setting.
3. Tap OK to save the change.
Note: The temperature and humidity settings are not measured values.
Therapy data
The AirCurve 11 device records your therapy data for viewing and adjusting by your care provider if
required. The data is transferred to your care provider in the following methods:
Wireless
The device is equipped with cellular communication that allows your sleep therapy data to be wirelessly
transmitted to your care provider. It also allows for prescribed settings to be applied or updated.
Transfer of data will occur after therapy has stopped. Leave your device connected to the power outlet at
all times and make sure it is not in Airplane Mode. Data will only be transferred if a wireless connection is
available.
Within the wireless network, the availability and quality of the network may be affected by terrain,
buildings, and the weather. Wireless communication depends on network availability. Coverage is not
available everywhere and varies by service.
Notes:
• Cellular feature may not work/ therapy data might not be transmitted if you use it outside of the country
or region of purchase.
•
Devices with cellular communication might not be available in all regions.
SD card
Your sleep therapy data may be transferred to your care provider via SD Card (if provided). Your care
provider may ask you to send the SD card by mail or to bring it in. Only remove the SD card when
instructed by your care provider.
To use the SD card to record your sleep data, remove the SD card cover.
Do not remove the SD card from the device when the SD light is flashing, because data is being written to
the card.
Note: The SD card should not be used for any other purpose as it may corrupt therapy data stored on the
card.
14
Climate Control
1. Tap Climate Control.
2. Tap Manual.
3. Tap OK to save the change.
Humidity Level
1. Tap Humidity Level.
2. Tap the preferred setting.
3. Tap OK to save the change.