ResMed AirCurve 11 VAUTO Mode D'emploi page 11

Pre-use check
Prior to use, the following steps shall be performed to determine if the device is operating correctly and
ready for use. If any problems occur, see the Troubleshooting section of this guide. Also refer to other
provided user instructions for troubleshooting information.
With the device powered off:
1. Check the condition of the device and accessories.
Inspect the device and all the provided accessories (eg. HumidAir 11 humidifier tub, air tubing, mask). If
there are any visible defects the component should not be used.
2. Check the air tubing set up.
Check the integrity of the air tubing. Connect the air tubing firmly to the outlet connector and other
accessories if in use.
With the device powered on:
When using the humidifier tub:
1. Fill the humidifier tub and check the water level does not exceed the maximum water level mark. Insert
the humidifier tub into the device.
2. From the Home screen tap MORE.
3. Tap Run Warmup. The screen should display the
humidity level has been set.
4. Check air is flowing through the air tubing. Press the Start Therapy/ Standby button or if SmartStart has
been enabled, breathe into the mask and therapy will start automatically.
When using the side cover:
1. Check the side cover is inserted correctly. It should click in place.
2. Check the display screen for any error messages.
3. Check air is flowing through the air tubing. Press the Start Therapy/ Standby button or if SmartStart has
been enabled, breathe into the mask and therapy will start automatically.
8
symbol if the humidifier is in use and the