ResMed AirCurve 11 VAUTO Mode D'emploi page 13

Using the touch screen:
There are two actions to navigate through the touch screen:
Swipe: Swipe up or down the screen to view menu options.
Tap: Select a parameter setting to update. For other parameters (eg Pressure Relief, Airplane mode), tap
the parameter to turn it on
Prescription settings
If you have received the device direct to your home, prescription settings may not have been applied to
your device. Ensure a wireless connection has been established to enable your care provider to install the
prescribed settings.
Personalizing your settings
The device can be set up for your needs by your care provider, but you may want to make adjustments to
make your therapy more comfortable.
1. Tap MY OPTIONS from the Home screen.
2. Tap the parameter you wish to change.
3. Tap the preferred setting.
Tap OK to confirm the change or CANCEL to go back to the previous screen.
Additional features
There are some other features on your device which you can personalize.
Note: Not all functions are available in all regions. Functions vary based on therapy mode.
Menu Function
MY Ramp Time
OPTIONS
Pressure
Relief*
Mask
Tube
SmartStart™* When SmartStart is enabled, therapy starts automatically when you breathe
SmartStop*
10
or tap to turn it off
Description
Period during which the pressure increases from a low start pressure to the
prescribed treatment pressure.
Ramp Time can be set to Off or 5 to 45 minutes (in 5-minute increments).
When EPR (Expiratory Pressure Relief) is enabled, you may find it easier to
breathe out. This setting can help you get used to therapy.
Allows you to select the type of mask used with the device.
Allows you to select the type of tubing used with the device.
into your mask.
When SmartStop is enabled, therapy stops automatically after a few
seconds when you remove your mask.
.