Télécharger Imprimer la page

Sentiotec home.com4 BLACK RS485 Mode D'emploi page 49

Masquer les pouces Voir aussi pour home.com4 BLACK RS485:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 126
Instructions for use for the user
When the door sensor is activated
● Use rotary selector 1 to select the remote start icon. Then press it
briefly to start the operating mode "Standby for remote operation".
► A countdown of 30 seconds is shown in the display (00:30).
The door can be opened and closed as many times as desired
during this time. After the countdown has elapsed, the door must
be closed!
► The sauna control unit is then ready to be started and stopped
using a remote start signal. It is not possible to manually operate
the sauna control unit at the same time.
► After a remote start and stop, the remote start icon goes out and
the mode has to be activated again.
Door is opened – warning "Door open" appears in the display:
– In "Standby for remote operation" mode:
To continue the mode, the door must be closed and the rotary selector
must be pressed in and simultaneously turned to the right.
The remote start symbol is shown in the display.
Press the rotary selector briefly to start the operating mode
"Standby for remote operation".
► The countdown (30 seconds) is shown again in the display
– In ongoing operation or if remote start output is enabled (for coin-op-
erated units):
Acknowledgement takes place automatically when the door is closed.
Cancelling standby for remote operation:
● To deactivate standby for remote control, press rotary selector 1
and at the same time turn it to the right.
p. 49/62
EN

Publicité

loading