Sentiotec home.com4 BLACK RS485 Mode D'emploi page 10

Instructions for installation and use
● Overheat cut-out
The overheat cut-out is installed in the housing for the heater sensor. If a
defect causes the sauna heater to continue heating after reaching the pre-
ferred temperature, the overheat cut-out switches the sauna heater off at a
temperature of around 139 °C.
● Real-time clock with weekly timer
● Post-drying program
After operation in combined mode, the post-drying program starts automatically
to prevent mould or rot from forming in the sauna cabin. This involves heating
the sauna cabin to 80 °C with the fan running for 30 minutes.
● Auxiliary output
Optional dimming (up to 500 W) or activation (up to 3.5 kW) for the additional
output.
The additional output has no overheat cut-out. For this reason, only intrinsically
safe devices should be operated using the additional output.
– If infrared heaters are connected to the additional output, they must
have an overheat cut-out.
– If infrared heat plates are connected to an additional output, the foil
sensor 1-014-445/P-ISX-FF must be used and activated on the tech-
nician menu (see "9.1. Technician menu" on page 33):
● Remote start function of two different operating modes or user programs.
● Colour light control via DMX
– Adjustment of colour, brightness, transition times and duration.
– Four colour light groups independently operable.
● Music playback via Bluetooth ®
– Integrated amplifier
● Operation via Bluetooth ® app
– Available for iOS and Android
● BUS connection
– Connection to house bus system via RS485 interface
– Connection to MySentio WIFI
p. 10/62