Angelo Po FX 201 E3 Manuel D'utilisation Et D'installation page 115

Alarm Fault
E06 Overload cutouts tripped
E07 Power board failure
The optional vacuum probe has
E08 failed or is not properly connect-
ed
Electrical component compart-
E10
ment has overheated
E11
Electronic circuit board diag-
E13
nostics tripped
E14
The humidity probe has failed or
E19
is not properly connected
E20 Setup error
The washing cycle has been in-
E21 terrupted because there is no
cleaner
The washing cycle has been in-
E22 terrupted because there is no
sanitizing cleaner
The washing cycle has been in-
E23 terrupted during the final saniti-
zation stage
E24 Automatic cleaning system fail-
E26 ure
System filling procedure not
E25
completed
English
Remedy
Inform the after-sales service
Inform the after-sales service
Press the "Reset" button
The oven solves the problem on
its own
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
Check the pipe position and the
level of cleaner in the tank; top
up if necessary and restart the
washing cycle.
Check the pipe position and the
level of sanitizing cleaner in the
tank; top up if necessary and re-
start the washing cycle
Press the reset button and rinse
the cooking chamber thorough-
ly by hand
Check that no residues of clean-
ing products have been left in-
side the cooking chamber
Check the position of the pipe-
and the level of the sanitizer in-
the container; if necessary, topit
up and re-launch the automat-ic
cleaning cycle
- 51 -
Notes
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle.
If the problem persists, call the
after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
If the problem persists, call the
after-sales service
If the problem persists, call the
after-sales service
If the problem persists, call the
after-sales service
If the problem persists, call the
after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
If the problem persists, call the
after-sales service
Use and installation manual
IT
GB
DE
FR
ES