Angelo Po FX 201 E3 Manuel D'utilisation Et D'installation page 113

8 – Spray on the polishing product and leave it to act for a few minutes.
9 – Rinse with warm (drinking quality) water and dry the surfaces of the cooking
chamber.
10 – Screw the screws back in to close the deflector panel (B).
11 – Replace the container rack and the filter mesh (A).
Caution - warning
On completion of the cleaning procedures, carry out a cooking cycle empty, in
"Steam" mode for 15 min. and for a further 15 min. in "Convection" mode at the
temperature of 150°C before reusing the appliance.
If the oven is to be unused for short periods, leave the cooking chamber open
to prevent condensation from forming.
TROUBLESHOOTING
The appliance has been tested before being put into service.
The information provided below is intended to assist in the identification and correction
of any anomalies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specific technical
knowledge or skill is required, and so they must only be carried out by qualified staff
with recognised experience acquired in the specific sector of operation.
Fault
The appliance does
switch on
Cooking cycle does not start
or stops suddenly
The cleaning cycle does not
start or stops suddenly
English
FAULT
Remedy
Fuse "blown"
Safety or protection
not (safety thermostat or overload
cutout) tripped
Electronic circuit board dam-
aged
Control board electronic circuit
board damaged
Alarm triggered
Control board electronic circuit
board damaged
Alarm triggered
- 49 -
Remedy
Replace the fuse (see page 61)
device
Press device reset button
Contact the after-sales service
Contact the after-sales service
Consult the "Key to Alarms" table
Contact the after-sales service
Consult the "Key to Alarms" table
6
Use and installation manual
IT
GB
DE
FR
ES