Angelo Po FX 201 E3 Manuel D'utilisation Et D'installation page 114

TABLE OF ALARM INDICATIONS
If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to identify
the alarm signals which appear on the display (A).
Important
Press button (D) to reset the alarm.
Alarm Fault
No water in chamber, or water
H2O
pressure too low
No water at drain, or water pres-
H2O.
sure too low
Oven door opening or closure
OPE
request
Indicates that cleaning is re-
CLE
quired
IT
The cooking chamber probe
GB
E01 has failed or is not properly con-
nected
DE
The core probe has a failure
FR E02 orhas not been properly con-
nected
ES
The steam discharge probe has
E03
failed
The motor-operated valve is not
E04
positioned correctly
E05 Safety thermostat failure
English
A
D
Remedy
Check that mains water is
present or adjust the pressure
(see page 59); if the problem
persists inform the after-sales
service
Check that mains water is
present or adjust the pressure
(see page 59); if the problem
persists inform the after-sales
service
Open or close the oven door
Inform the after-sales service if
this message continues to be
displayed
Launch an automatic cleaning-
cycle
Inform the after-sales service
Check the position of the prod-
uct core probe or inform the af-
ter-sales service if it is faulty
Inform the after-sales service
Switch on the oven again and if
the problem persists inform the
after-sales service
Inform the after-sales service
- 50 -
IDM-39617700700.tif
Notes
Convection cooking cycles can
still be carried out
Convection and steam cooking
cycles can still be carried out
The cooking cycle does not start
until the door has been opened
or closed as required
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Cooking cycles with product
core probe cannot be carried
out
Convection and steam cooking
cycles can still be carried out
Convection and steam cooking
cycles can still be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Use and installation manual