Yamaha YZ125/LC Manuel D'atelier Du Proprietaire page 552

Masquer les pouces Voir aussi pour YZ125/LC:

9 If the machine is new and after it is broken in,

the same set length of the spring may change

because of the initial fatigue, etc. of the spring.

Therefore, be sure to make re-evaluation.

9 If the standard figure cannot be achieved by

adjusting the spring adjuster and changing the

spring set length, replace the spring with an

optional one and make re-adjustment.

Setting of spring after replacement

After replacement, be sure to adjust the spring to

100 mm (3.5~3.9 in)] and set it.

1. Use of soft spring

9 Set the soft spring for less rebound damp-

ing to compensate for its less spring load.

Run with the rebound damping adjuster

one or two clicks on the softer side and

readjust it to suit your preference.

2. Use of stiff spring

9 Set the soft spring for more rebound damp-

ing to compensate for its greater spring

load. Run with the rebound damping

adjuster one or two clicks on the stiffer side

and readjust it to suit your preference.

Adjusting the rebound damping will be fol-

lowed more or less by a change in the com-

pression damping. For correction, turn the

low compression damping adjuster on the

softer side.