Yamaha YZ125/LC Manuel D'atelier Du Proprietaire page 446

HANDLEBAR
4. Install:
9 Throttle cable 1
To tube guide 2.
NOTE:
Apply the lithium soap base grease on the throt-
tle cable end and tube guide cable winding por-
tion.
5. Install:
9 Roller 1
9 Collar 2
NOTE:
9 Apply the lithium soap base grease on the
roller sliding surface.
9 Install the roller so that the "UPPER" mark a
faces upward.
9 Pass the throttle cable in the groove b in the
roller.
6. Install:
9 Throttle cable cap 1
9 Screw (throttle cable cap) 2
7. Adjust:
9 Throttle grip free play
Refer to "THROTTLE CABLE ADJUST-
MENT" section in the CHAPTER 3.
8. Install:
9 Cap cover 1
9. Install:
9 Master cylinder 1
9 Master cylinder bracket 2
9 Bolt (master cylinder bracket) 3
NOTE:
9 Install the bracket so that the arrow mark a
faces upward.
9 First tighten the bolt on the upper side of the
master cylinder bracket, and then tighten the
bolt on the lower side.
5-43
CHAS
1 Nm (0.1 m•kg, 0.7 ft•lb)
9 Nm (0.9 m•kg, 6.5 ft•lb)