Yamaha YZ125/LC Manuel D'atelier Du Proprietaire page 176

REAR BRAKE PAD INSPECTION AND REPLACEMENT
9 Remove the pad pin 6 and brake pads 7.
9 Connect the transparent hose 8 to the
bleed screw 9 and place the suitable con-
tainer under its end.
9 Loosen the bleed screw and push the
caliper piston in.
cC
Do not reuse the drained brake fluid.
9 Tighten the bleed screw.
Bleed screw:
6 Nm (0.6 m•kg, 4.3 ft•lb)
9 Install the brake pads 0 and pad pin q.
NOTE:
9 Install the brake pads with their projections
a into the caliper recesses b.
9 Temporarily tighten the pad pin at this point.
9 Install the caliper w and rear wheel e.
Refer to "FRONT WHEEL AND REAR
WHEEL" section in the CHAPTER 5.
9 Tighten the pad pin r.
Pad pin:
18 Nm (1.8 m•kg, 13 ft•lb)
9 Install the pad pin plug t and protector y.
Pad pin plug:
3 Nm (0.3 m•kg, 2.2 ft•lb)
Bolt (protector):
7 Nm (0.7 m•kg, 5.1 ft•lb)
3. Inspect:
9 Brake fluid level
Refer to
INSPECTION" section.
4. Check:
9 Brake pedal operation
A softy or spongy feeling ¡ Bleed brake
system.
Refer to "BRAKE SYSTEM AIR BLEEDING"
section.
3-22
INSP
ADJ
"BRAKE FLUID LEVEL