Publicité
Les langues disponibles
Les langues disponibles
9.3.2 U
SING A MATCH
1
Place a match in the match holder.
2
Open the lid and set the control knob of the side burner to
OFF.
3
If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
4
Light the match and hold it about 13 mm from the side
burner.
5
Set the control knob of the side burner to HIGH.
6
If the side burner does not light within 5 seconds, set its
control knob to OFF, close the gas supply and wait 5
minutes. This allows any accumulated gas to escape.
7
Retry lighting the side burner. If it still does not light, refer to
"14 Troubleshooting" to determine the cause of the problem.
9.4 Switching the burners off
If you no longer use the burners, you have to switch them off.
Proceed as follows:
1
Close the gas supply.
2
Set the control knobs of the burners to OFF.
By closing the gas supply first, you make sure there is no
2
gas left in the appliance.
9.5 Relighting the burners
If a burner goes out while in use, proceed as follows:
1
Open the lid and close the gas supply.
2
Set all control knobs to OFF and wait 5 minutes. This allows
any accumulated gas to escape.
3
Relight the burner(s).
12
All manuals and user guides at all-guides.com
9.6 Checking the flames
Each time you light a burner, you have to check its flames. A
perfect flame is almost completely blue, with some yellow at the
top. Sporadic yellow flames are normal and not harmful.
If there is something wrong with the flames, do one of the
following to solve the problem:
www.barbecook.com
If the flames are...
1
Low and entirely yellow
2
1
Higher than the bowl
2
3
4
LOW
Do the following...
Immediately close the gas supply and
set all control knobs to OFF.
Refer to "14 Troubleshooting" to
determine the cause of the problem.
Most likely, the venturis are blocked.
Immediately close the gas supply and
set all control knobs to OFF.
Wait 5 minutes to allow any
accumulated gas to escape.
Relight the burner(s).
If the problem persists, refer to
"14 Troubleshooting" to determine
the cause of the problem.
HIGH
Publicité
