Data Regarding Noise Emission Values; Emc Measures; Safety Symbols; Disposal - Fronius Symo Serie Instructions De Service

It is impossible to guarantee that externally procured parts are designed and manufactured
to meet the demands made on them, or that they satisfy safety requirements. Use only
original spare parts (also applies to standard parts).
Do not carry out any alterations, installations, or modifications to the device without first ob-
taining the manufacturer's permission.
Components that are not in perfect condition must be changed immediately.
Data Regarding
Noise Emission
Values

EMC Measures

In certain cases, even though a device complies with the standard limit values for emis-
sions, it may affect the application area for which it was designed (e.g., when there is sen-
sitive equipment at the same location, or if the site where the device is installed is close to
either radio or television receivers). If this is the case, then the operator is obliged to take
appropriate action to rectify the situation.

Safety symbols

Devices marked with the CSA test mark satisfy the requirements of the relevant standards
for Canada and the USA.

Disposal

Dispose of in accordance with the applicable national and local regulations.

Backup

The user is responsible for backing up any changes made to the factory settings. The man-
ufacturer accepts no liability for any deleted personal settings.

Copyright

8
The cooling of the device takes place via an electronic temperature control
system at the lowest possible noise level and depends on the power used, am-
bient temperature and the soiling level of the device, etc.
It is not possible to provide a workplace-related emission value for this device,
because the actual sound pressure level is heavily influenced by the installa-
tion situation, the power quality, the surrounding walls and the properties of
the room in general.
Copyright of these operating instructions remains with the manufacturer.
Text and illustrations are technically correct at the time of going to print. The
right to make modifications is reserved. The contents of the operating instruc-
tions shall not provide the basis for any claims whatsoever on the part of the
purchaser. If you have any suggestions for improvement, or can point out any
mistakes that you have found in the operating instructions, we will be most
grateful for your comments.