Qualified Service Engineers; Data Regarding Noise Emission Values; Emc Measures; Safety Symbols - Fronius Symo 10.0-3 208-240 Instructions De Service

Qualified Service
Engineers
Data Regarding
Noise Emission
Values

EMC Measures

Safety symbols

Disposal

8
The servicing information contained in these operating instructions is intended
only for the use of qualified service engineers. An electric shock can be fatal.
Do not carry out any actions other than those described in the documentation.
This also applies to qualified personnel.
All cables and leads must be secured, undamaged, insulated, and adequately
dimensioned. Loose connections, scorched, damaged, or under-dimensioned
cables and leads must be repaired immediately by an authorized specialist.
Maintenance and repair work must only be carried out by authorized person-
nel.
It is impossible to guarantee that externally procured parts are designed and
manufactured to meet the demands made on them, or that they satisfy safety
requirements. Use only original spare parts (also applies to standard parts).
Do not carry out any alterations, installations, or modifications to the device
without first obtaining the manufacturer's permission.
Components that are not in perfect condition must be changed immediately.
The cooling of the device takes place via an electronic temperature control
system at the lowest possible noise level and depends on the power used, am-
bient temperature and the soiling level of the device, etc.
It is not possible to provide a workplace-related emission value for this device,
because the actual sound pressure level is heavily influenced by the installa-
tion situation, the power quality, the surrounding walls and the properties of
the room in general.
In certain cases, even though a device complies with the standard limit values
for emissions, it may affect the application area for which it was designed (e.g.,
when there is sensitive equipment at the same location, or if the site where the
device is installed is close to either radio or television receivers). If this is the
case, then the operator is obliged to take appropriate action to rectify the situ-
ation.
Devices marked with the CSA test mark satisfy the requirements of the rele-
vant standards for Canada and the USA.
Dispose of in accordance with the applicable national and local regulations.