Publicité
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
Å
REAR BRAKE ADJUSTMENT/
ı
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
Brake pedal height a
G
Out of specification → Adjust.
Brake pedal height a:
5 mm (0.20 in)
2. Adjust:
Brake pedal height
G
Pedal height adjustment steps:
Loosen the locknut 1.
G
Turn the adjusting nut 2 until the pedal
G
height a is within specified height.
Tighten the locknut.
G
WARNING
Adjust the pedal height between the
G
maximum Å and the minimum ı as
shown. (In this adjustment the bolt 3
end b should protrude out of the
threaded portion 4 but not be less than
2 mm (0.08 in) c away from the brake
pedal 5).
After the pedal height adjustment, make
G
sure that the rear brake does not drag.
EC365080
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
Brake pad thickness a
G
Out of specification → Replace as a
set.
Brake pad thickness a:
Standard
4.4 mm (0.17 in)
2. Replace:
Brake pad
G
Brake pad replacement steps:
Remove the pad pin plug 1.
G
3 - 26
INSP
ADJ
<Limit>
1.0 mm (0.04 in)
Publicité
