Franke CM 85 M Conseils D'utilisation Et D'installation page 25

Removing the side frames
– Bend the crosspiece engaged in the fixing bush downwards and remove it from the groove.
– Tilt the frame upwards by approx. 60° and push it slightly in the direction of inclination.
– Keeping the frame tilted, remove the two top hooks from the respective holes.
Fitting the side frames
– Keeping the frame tilted, insert the top hooks in the respective holes, pushing lightly in the direction of inclination.
– With the frame tilted, pull in the direction of inclination until the top hooks stop against the outside of the
compartment wall.
– Turn the frame towards the compartment wall. Bend the crosspiece engaged in the fixing bush downwards and
remove it from the groove.
Replacing the oven lamp
Franke ovens are equipped with two rectangular lamps. To replace the oven lamp,
proceed as follows:
– disconnect the power by means of the omnipolar switch used for connecting it to the
electrical system or, if the plug is accessible, unplug the appliance;
– remove the glass cover (A), prising it off with a flat screwdriver;
– unscrew the lamp and replace it with one resistant to high temperatures (300 °C),
with the following characteristics:
Voltage: 220/240 V ~ 50-60 Hz
Power: 15 W
Connection: (E14) small.
Support
In the event of any operation problems, contact a Franke Technical Service Centre
(refer to the attached list).
Never use the services of unauthorised technicians.
Specify:
– type of fault;
– appliance model (Art.);
– serial number (S.N.).
This information is given on the appliance data plate, on the warranty certificate.
Safety instructions
• This appliance is not intended for use by persons (including children) with limited mental or motor abilities or
without experience and knowledge of it, unless supervised or instructed in its use by someone responsible for their
safety.
• Children must be supervised to ensure that they do not play with the appliance.
• The Manufacturer declines any liability for damage due to: incorrect installation, improper, incorrect or unreasonable
use.
Always contact qualified personnel in the following cases:
To ensure safe and efficient operation of this electrical appliance:
– only contact authorised service centres;
– always demand the use of original spare parts;
– the appliance is designed for non-professional household use; do not modify its features;
– the data plate lists the symbols indicating the countries to which the instructions apply;
– appliance electrical safety is guaranteed only when it is connected to an earthing system in compliance with current
regulations;
– do not touch the heating elements or any parts of the oven door during use, since they become very hot,
and in particular keep children away.
Do not allow children to touch:
– the controls and the appliance in general;
– the packing elements (bags, polystyrene, staples, etc.);
– the appliance during and immediately after oven use, since it becomes very hot;
– the appliance when not used (make any potentially hazardous parts safe).
24
All manuals and user guides at all-guides.com
A