Panasonic AG-DTL1P Manuel D'utilisation page 76

RS-232C
$ Time lapse control commands
These commands are not acknowledged while a search control command is being processed.
Data transmitted by PC
[STX] LBR:m [ETX]
Parameter
m = N: Buzzer ON
F: Buzzer OFF
[STX] LBZ:m [ETX]
Parameter
m = N: Buzzer ON
F: Buzzer OFF
[STX] LMS:m [ETX]
Parameter
m = 0: 1 second
1: 1.5 seconds
2: 2 seconds
3: 2.5 seconds
4: 3 seconds
5: 4 seconds
6: 5 seconds
7: 10 seconds
[STX] LDA:m [ETX]
Parameter
m = C: CONTINUE
Control signals continue to
be output even after
recording.
A: ALARM REC
Control signals are output
only during alarm recording
and sensor recording.
[STX] LDF:m [ETX]
Parameter
m = I: Field recording
R: Frame recording
[STX] LDM:m [ETX]
Parameter
m = F: OFF
Alarm signal input is
ignored.
M: ALARM/SENSOR
Alarm recording or sensor
recording is performed.
A: ALARM
Alarm recording is
performed.
S: SENSOR
Sensor recording is
performed.
Data returned from unit in response
[STX] LBR [ETX]
[STX] LBZ [ETX]
[STX] LMS [ETX]
[STX] LDA [ETX]
[STX] LDF [ETX]
[STX] LDM [ETX]
76
Description of command
Sets whether the buzzer is to sound when REC REVIEW
reveals that the proper video level was not maintained.
Sets whether the buzzer is to sound during alarm recording
and sensor recording.
Sets the timing at which to switch the video signals which
are supplied from the camera and which are to be output
from the rear panel VIDEO OUT connector.
Sets how the control signals are to be output to the
component connected to ALARM OUT on the rear panel
terminal section when alarm recording or sensor recording
is performed.
Sets whether field recording or frame recording is to be
performed for alarm recording and sensor recording.
Sets what recording is to be performed when an alarm
signal has been input.