Panasonic AG-DTL1P Manuel D'utilisation page 53

RS-232C
The following functions can be controlled by using the
RS-232C interface.
$ Basic operations
The same basic operations as those performed by
the unit's buttons and switches can be initiated.
$ Status checks
The unit's current operation mode can be checked.
$ Setting menus
The setting menu items can be detected and set.
$ Search function
Specific frame positions can be searched.
1. Hardware specifications
(1) Interface specifications
Connector:
D-Sub 9-pin
DCE specifications (straight cable supported)
Pin No. Signal
1 GND
2 SD (TXD)
3 RD (RXD)
4 ER (DTR)
5 SG
6 DR (DSR)
7 CS (CTS)
8 RS (RTS)
9 N.C
Description
GND
Transmitted Data
Received Data
Data Terminal Ready
Signal GND
Data Set Ready
Clear to Send
Request to Send
=====
Example of connections (9P)
PC side
1 CD
3 SD
2 RD
7 RS
8 CS
6 DR
5 SG
4 ER
Example of connections (25P)
PC side
1 FG
2 SD
3 RD
4 RS
5 CS
6 DR
7 SG
20 ER
(2) Communication parameters
The unit's communication parameters are as follows.
To change any of these parameters, make the
changes on the menus.
Baud rate : 9600 bps
Bit length : 7 bits
Stop bit : 1 bit
Parity : Odd
53
Unit side
1 GND
3 RD (RXD)
2 SD (TXD)
7 CS (CTS)
8 RS (RTS)
6 ER (DTR)
5 SG
4 DR (DSR)
Unit side
1 GND
3 RD (RXD)
2 SD (TXD)
7 CS (CTS)
8 RS (RTS)
6 ER (DTR)
5 SG
4 DR (DSR)