Publicité
Les langues disponibles
Les langues disponibles
RS-232C
$ Time lapse control commands
These commands are not acknowledged while a search control command is being processed.
Data transmitted by PC
[STX] LAD:m [ETX]
Parameter
m = 0: 30 seconds
1: 1 minute
2: 1 minute and 30 seconds
3: 2 minutes
4: 3 minutes
5: 6 minutes
6: 10 minutes
7: CONTINUE:
Recording continues until
the tape-end.
8: MANUAL:
Recording only while an
alarm signal is input.
[STX] LAI:m [ETX]
Parameter
m = S: STOP
Stop mode established at
tape-end position.
C: CONTINUE
Alarm signal input is
ignored.
[STX] LAR [ETX]
[STX] LBM:m [ETX]
Parameter
m = N: ON
Output of the black burst
signal.
F: OFF
No output of the black burst
signal.
[STX] LBP:m [ETX]
Parameter
m = ¢: Video signals of all the
cameras are output.
0: Camera 1
1: Camera 2
2: Camera 3
3: Camera 4
4: Camera 5
5: Camera 6
6: Camera 7
7: Camera 8
8: Camera 9
9: Camera 10
A: Camera 11
B: Camera 12
C: Camera 13
D: Camera 14
E: Camera 15
F: Camera 16
Data returned from unit in response
[STX] LAD [ETX]
[STX] LAI [ETX]
[STX] LAR [ETX]
[STX] LBM [ETX]
[STX] LBP [ETX]
75
Description of command
Sets the time during which alarm recording or sensor
recording is to be performed.
Sets the operation mode that is to be established when an
alarm signal has been input at the tape-end position.
Deletes the ALARM RECALL data.
Sets the processing to be performed for the black burst
signal when the video signals to be output from the video
signal output connectors are switched.
Prevents the video signals of the camera designated by the
parameter from being output from the VIDEO OUT
connector.
Publicité
