Ducati 749S 2002 Manuel D'utilisation Et Entretien page 156

Note
Main wiring harness cable does not need to be
disconnected to replace the headlamp bulbs.
Note
Be careful to hold the new bulb at the base only.
Never touch the transparent body with your fingers or it
will blacken resulting in reduced bulb brilliancy.
E
Refitting
After changing the burnt-out bulb, connect the
instrument panel connector to the main wiring harness,
locate the instrument panel to the rubber grommets and
refit panel.
Refit the bottom cover and the headlamp fairing and
secure them using the retaining screws. Make sure the
turn indicator wires are correctly routed in the grooves
inside headlamp supports.
Changing the parking light bulb
Remove headlight fairing (see page 54), detach
instrument panel connector (2, fig. 67) from wiring and
put your hand into the headlamp support to grasp the
parking light bulb (1).
Extract the bulb holder from its seat and change the
bulb. Then reconnect intrument panel wiring and properly
position it on its buffers.
66
5
5
5
4
5
fig. 68
1
fig. 69