Ducati 749S 2002 Manuel D'utilisation Et Entretien page 106

Setting special function (vehicle model and units of
measurement)
The engine control unit transmits the correct vehicle
model and unit measurement information automatically
for the instrument panel to display. To force a change of
these parameters, turn the key from OFF to ON while
holding down both buttons (1) and (2).
Press the button (1) to scroll through available
configurations.
To store your selection, hold down the button (2) for 5
E
seconds, until the display will read OFF. Set the key to
OFF.
Note
The dotted boxes in the figure are the display areas
for vehicle version (normal, R or S).
Lap time recording (fig. 10 and 11)
This function lets you record lap time and displays top
speed and engine rpm during that lap.
Select the LAP mode in the display (4)(see page 14).
Press the engine start button (5) while riding to start the
on-board chronometer. Pressing the button (5) again will
stop the chronometer.
Note
In the LAP mode, the engine may not be started
using the starter button (5).
16
fig. 9