Ducati 749S 2002 Manuel D'utilisation Et Entretien page 133

DIRECTIONS FOR USE
Running-in recommendations
Max. rotation speed (fig. 40)
Rotation speed for running-in period and during standard
use (rpm):
1) up to 1000 km;
2) from 1000 to 2500 km;
3) after 2500 km.
Up to 1000 km
During the first 1000 km, keep an eye on the revolution
meter. The indicator must not exceed:
5500-6000 rpm.
During the first hours of riding, it is advisable to run the
engine at varying load and rpm, though still within
recommended limit.
To this end, roads with plenty of bends and even slightly
hilly areas are ideal for a most efficient running-in of
engine, brakes and suspensions.
For the first 100 km, use the brakes gently. Do not brake
violently or keep brake applied for too long. This will
enable a correct break-in of friction material on brake
pads against brake discs.
For all mechanical moving parts of the motorcycle to
adapt to one another and above all not to adversely affect
the life of basic engine parts, it is advisable to avoid harsh
accelerations and not to run the engine at high rpm for
too long, especially uphill.
Furthermore, the drive chain should be inspected
frequently. Lubricate it as required.
From 1000 to 2500 km
At this point, you can squeeze some more power out of
your engine, being careful, however, to never exceed:
7000 rpm.
Important
During the whole running-in period, the
maintenance and service rules recommended in the
warranty card should be observed carefully.
Failure to comply with these rules will release Ducati
Motor Holding S.p.A. from any liability whatsoever for
any engine damage or shorter engine life.
E
43