Nilfisk RS 851 Instructions D'origine page 126

ENGLISH USER MANUAL
• Consultation of B_BOX
alarms occurred after the last memory reset are stored.
The alarm is identifi ed by a number code that can be
displayed as shown below: repeatedly press the upper
part of the push-button (15, Fig. D) until "MAIN MENU"
appears. Confi rm by pressing the lower part of the
push-button (15, Fig. D). The arrow cursor (6, Fig. J)
will be placed near the word "STATUS". Press the lower
part of the push-button (15, Fig. D) again to bring the
arrow cursor near the word "MAINTENANCE". Confi rm
by pressing the upper part of the push-button (15, Fig.
D). On the display (17) the page "MAINT.01" is shown;
when pressing the upper part of the push-button (15)
again, the page "MAINT.02" is shown. When pressing
the lower part of the push-button (15, Fig. D), the
cursor aligns with B_BOX, then enter the B_BOX by
pressing the upper part of the push-button (15). In this
page, the fi rst series of numbers (8, Fig. J) indicates
the alarm identifi cation number, while the second series
of numbers (9) indicates the time at which the alarm
occurred. The stored alarms are up to 16 displayed
on four pages, which can be scrolled by pressing the
push-button (15, Fig. D) repeatedly.
CAUTION!
In the B_BOX the alarms are stored one
after the other, so when the alarms are
detected, always check for the time at
which the alarm occurred to have a real
chronology of the alarms.
10 33018305(3)2010-01 A
(7, Fig. J), where all the Combination switch functions:
– Headlights off, with mark (35b) at the symbol O
– Running lights on, with mark (35b) at the symbol
– Low beam on, with mark (35b) at the symbol
the combination switch is in this position, the working light
turns on too.
– High beam on, with mark (35b) at the symbol
lowered lever (35a)
– High beam temporary on, lifting the lever (35a)
– Right turn signal on, bringing the lever (35a) forward
– Left turn signal on, bringing the lever (35a) backward
– Horn activation, pushing the lever (35a) in the direction
shown by the arrow (35c)
(See Fig. E)
1. Serial number plate/technical data/conformity certifi cation
2. Cab vents
3. Ceiling light
4. Cab air recirculation vents
5. Climate control knob
6. Cab air fl ow control knob
7. Brake fl uid tank (**)
8. Suction fan/optional equipment lever
9. High-pressure water gun
10. Dust control system nozzle valve:
• Suction hose (from suction inlet to hopper)
• Rear suction pipe (*)
11. Side broom dust control system nozzle valve
12. 3rd broom dust control system nozzle valve
13. Parking brake lever
14. Driver's seat
15. Cab heater control knob
16. Diesel engine throttle lever
17. Driver's seat forward/backward adjustment lever
18. Driver's seat safety belt
19. Emergency stop push-button
20. Accessory distributor pressure inlet
(*) Optional
(**) In the machines with right-hand drive, these components
are on the right side of the driver's seat.
RS 851
. When
and