Steering System - Nilfisk RS 851 Instructions D'origine

ENGLISH
Problem
HOPPER AND RELEVANT DOOR
The hopper does not lift/dump
The hopper does not return to horizontal
position/lower
The hopper door does not open/close
The hopper door does not open/close
The hopper door does not open/close
DUST CONTROL SYSTEM NOZZLES
No water from the nozzles
No water to the nozzles
The water pump does not stop

STEERING SYSTEM

The machine does not move straightforward
The steering is hard
46
USER MANUAL
The distributor is stuck
There is an open in the push-button
The fuse is burned
Open safety push-button
The broom switch is turned on
The cylinder gaskets are worn
The fuse is burned
There is an open in the push-button
Open safety push-button
The relay electronic board is faulty
The solenoid valves are burned
There is no voltage in the actuator
Open control push-button
The actuator cams are misadjusted
The actuator is faulty
The machine is moving
There is no voltage in the actuator
Open control push-button
The actuator cams are misadjusted
The actuator is faulty
The machine is moving
There is no voltage in the actuator
Open control push-button
The actuator cams are misadjusted
The actuator is faulty
The machine is moving
The display is disconnected or faulty
The water fi lter is clogged
The nozzles are clogged
The water pump relay is burned
The pump does not operate
The water pump switch is off
The fuse is burned
The water pump relay is burned
The water tanks are empty
The fl oat is stuck
The fl oat is not properly installed
The rear axle toe-in is incorrect
The power steering is faulty
The priority valve is faulty
The rear wheel hydraulic control cylinder is
faulty
33018305(3)2010-01 A
Possible cause
RS 851
Remedy
Repair
Replace
Replace
Replace
Turn off
Overhaul the cylinders
Replace
Replace
Replace
Replace
Replace
Repair the electrical system
Replace
Adjust the actuator cams
Replace
Stop the machine
Repair the electrical system
Replace
Adjust the actuator cams
Replace
Stop the machine
Repair the electrical system
Replace
Adjust the actuator cams
Replace
Stop the machine
Check/reset the connections or replace the
display
Clean/replace
Clean
Replace
Repair/replace
Turn on
Replace
Replace
Fill the tanks
Repair
Install properly
Adjust
Replace
Replace
Replace