APRILIA MOJITO 50 2004 Usage Et Entretien page 353

M50 MC50
To remove and clean the spark plug:
◆
Take off the spark plug cap (1).
◆
Remove all the dirt from the base of the
spark plug, then unscrew it with the
spanner you will find in the tool kit and
extract it from its seat, taking care that
neither dust nor other substances enter
the cylinder.
◆
Make sure that there are neither carbon
deposits, nor corrosion marks on the
electrode and on the central porcelain
part; if necessary, clean them with the
special cleaners for spark plugs, with an
iron wire and/ or a metal brush.
◆
Energetically blow some air, in order to
prevent the removed residues from get-
ting into the engine.
If the spark plug has crackings on the in-
sulating material, corroded electrodes or
excessive deposits, it must be changed.
M125 M150
MC125 MC150
◆
Check the spark plug gap with a thick-
ness gauge.
The gap must be:
√ 0,6 - 0,7 mm
M50 MC50
(0.024 - 0.028 inc);
√ 0,7 - 0,8 mm
M125 MC125 M150 MC150
(0.028 - 0.031 inc);
if necessary adjust it, carefully bending
the earth electrode.
◆
Make sure that the washer is in good
conditions. With the washer on, screw
the spark plug by hand in order not to
damage the thread.
◆
Tighten the spark plug by means of the
spanner you will find in the tool kit, giving
it half a turn to compress the washer.
Spark plug driving torque:
– 20 Nm (14.46 ftlb);
M50 MC50
– 12-14 Nm
M125 MC125 M150 MC150
(8.64- 10.13 ftlb).
M50 MC50
(0.024 - 0.028 inc) (0.024 - 0.028 inc)
M125 M150
MC125 MC150
(0.028 - 0.031 inc) (0.028 - 0.031 inc)
!
CAUTION
The spark plug must be well tightened,
otherwise the engine may overheat and
be seriously damaged.
Use the recommended type of spark
plug only, see p. 83 (TECHNICAL DA-
TA), in order not to compromise the life
and performance of the engine.
◆
Position the spark plug cap (1).
◆
Put back the inspection cover.
use and maintenance Mojito 50/125/150 - Mojito Custom 50/125/150
65