Altering The Hardware Programming Enable; Altering The Mounting Position - HYDAC ELECTRONIC ETS 1700 Mode D'emploi

9.2. ALTERING THE HARDWARE PROGRAMMING ENABLE

 Disconnect the unit from the supply voltage.
 Remove the 4 screws from the unit front panel (Figure 1).
 Lift front panel off carefully and put to one side.
 Push slide switch on the lower board to the required position (Figure 2):
E
"OFF": programming disabled.
 Replace front panel on the unit and screw into position, ensuring that the
front panel seal is in the correct position.

10. Altering the mounting position

 Disconnect the unit from the supply voltage.
 Remove the 4 screws from the front plate of the unit (Figure 1).
 Carefully lift off the front panel and turn through 180°.
 Replace the front panel on the unit and screw into position, ensuring that the
front panel seal is in the correct position (Figure 2).
32
Figure 1
sensor connection
Figure 1
programming
possible
disable
Figure 2
Figure 2
sensor connection