Bar; According To Desina ® Standard - HYDAC ELECTRONIC EDS 3000 Manuel D'instructions

11. Model codes (also order codes)
11.1. eds 3000 witH ceramic sensor cell;
absolute and relative pressure
E
Model (technology)
1 = ceramic absolute
3 = ceramic relative
Type of connection, mechanical
1 = g 1/2 b din-en 837 male thread
4 = g 1/4 a male thread
9 = g 1/4 female thread to din 3852
Type of connection, electrical
6 = 4-pole plug m12x1
only possible on output models
"1", "2" and "3"
(connector not included)
8 = 5-pole plug m12x1
only possible on output model "5"
(connector not included)
Output
1 = 1 switching output (only in conjunction
with electrical connection type "6")
2 = 2 switching outputs (only in conjunction
with electrical connection type "6")
3 = 1 switching output and 1 analogue output (only in
conjunction with electrical connection type "6")
5 = 2 switching outputs and 1 analogue output (only
in conjunction with electrical connection type "8")
Pressure ranges in bar
type 1 (ceramic absolute)
0001; 02.5
type 3 (ceramic relative)

0001 (-1 .. 1 bar); 01.0; 02.5; 06.0; 0010; 0016

Modification number
000 = standard (determined by manufacturer)
Material of seal (in contact with medium)
f = fpm seal (e.g. for hydraulic oils)
e = epdm seal (e.g. for water, refrigerants)
connection material (in contact with medium)
1 = stainless steel
50
≤
16 bar
EDS 3 X X X - X - XXXX - XXX - X X
11.2. eds 3000 witH ceramic sensor cell;
absolute and relative pressure
®
according to desina standard
EDS 3 X X 8 - X - XXXX - D00 - X X
Model (technology)
1 = ceramic absolute
3 = ceramic relative
Type of connection, mechanical
1 = g 1/2 b din-en 837 male thread
4 = g 1/4 a male thread
9 = g 1/4 female thread to din 3852
Type of connection, electrical
8 = 5-pole plug m12x1
(connector not included)
Output
1 = 1 switching output
3 = 1 switching output and 1 analogue output
Pressure ranges in bar
type 1 (ceramic absolute)
0001; 02.5
type 3 (ceramic relative)
0001 (-1 .. 1 bar); 01.0; 02.5; 06.0; 0010; 0016
Modification number
D00 = pin configuration conforms to DESINA
with self-monitoring
Material of seal (in contact with medium)
f = fpm seal (e.g. for hydraulic oils)
e = epdm seal (e.g. for water, refrigerants)
connection material (in contact with medium)
1 = stainless steel
≤
16 bar
E
standard
®
51