Burkert 8400 Manuel D'utilisation page 17

Installation and wiring
→ Unscrew the nut [1] on the body [4].
4 3 2 1
→ Insert the cable into the nut [1], the
cable clamp [2] and the seal [3], and
then into the body [4].
→ Strip 20 mm of the cable.
→ Cut the central wire (earth) so that its
length is equal to 11.5 mm.
→ Expose 5.5 mm of the wires on the
stripped cable.
→ Insert each wire into the appropriate
pin on the terminal block [5] (see
chapter 7.3.2 and 7.3.3).
→ Tighten the terminal block [5] wired to
the body [4]
→ Tighten the connector nut [1].
Fig. 6: Assembling an M12 female connector (not provided)
7.3.2. Wiring on an 8400 with M12, 5-pin
fixed connector and transistor output
PNP transistor output
3
4
(*)
5
1 2
V+ (12 - 30 VDC) NPN transistor output
Fig. 7: Assignment of the pins on the M12, 5-pin fixed con-
nector on a version with transistor output
Type 8400
0 VDC
(*) Functional earth
Pin for the M12 female cable available as
optional equipment (order code 438680)
1
2
3
4
5
The M12, 5-pin fixed connector is adjustable:
→ Unscrew the locknut.
Do not turn the fixed connector by more than 360° so as
not to twist the cables inside the housing
→ Turn the fixed connector until it is in the desired position.
→ Tighten the locknut using a spanner, while keeping the fixed
connector in the desired position.
4
3
blue
white
5
2
1
1A
+ -
Power supply
12-30 VDC
Fig. 8: Wiring an NPN transistor output
english
Colour of the
conductor
brown
white
blue
black
green/yellow
or grey
Charge
17