21 - Gas Cooktop Operation
EN
Gas Control Knob Setting
Electric gas ignition
The gas burner use an electric ignition device located near
each burner that ensures burner ignition.
ELECTRIC IGNITION
Models with automatic ignition
The electronic auto ignition, lights the surface burner when
the corresponding control knob is turned at any valve rotation
allows admits sufficient gas flow to support a flame.
To set:
• Push and turn a knob counter clockwise to any setting, all
spark plugs will generate a clicking sound (spark), however
only the burner with the control knob adjusted to the
range will produce a flame.
WARNING
• Do not operate a burner using empty cookware or without
cookware on the grate.
• Do not touch the burner when the igniters are clicking
(sparking).
• Do not let the burner flame extend beyond the edge of
the pan.
• Turn off all controls when not cooking.
Failure to follow these instruction can result in personal injury
or fire.
34
Gas burners
The gas burners design of these cooktop models, allow a
pleasing option for cooking where size, power and simmering
are a primary concern.
Burners with two flame rings
This special burner has two separate flame rings to provide a
complete heat regulation from high power to simmering.
To set :
1. Push and turn the knob counter clockwise withing the main
-
range, when the burner is turned on, the main flame
and the Simmer flame will both ignite and remain on.
2. Set desired temperature within the main
Simmer setting
Continue turning the knob counter-clockwise to the '
SIMMER' range.
temperature adjustment can be made using the inner flame
ring only.
Turning off the burner
Turn the knob clockwise as far as it will go to the off position.
Ensure flame extinguishes fully.
-
-
range.
The outer flame ring will go out and
KNOB BURNER
-