Note For Ice Maker With Vertical Evaporator System; Electronic Timer (Optional Function); Start - Bartscher 104.825A Mode D'emploi

To access pump filter and pump side of inner basin, see chapter 6.

11.5 NOTE FOR ICE MAKER WITH VERTICAL EVAPORATOR SYSTEM

Perform cleaning and sanitizing operations as described in chapters 10 and 11, in accordance with the following instructions:
E N
E N
• to remove evaporator cover (15) and ice-cube slide (2) and extract overflow pipe (3), see Fig. 29
• to remove sprayer bank (4) and the corresponding side caps (5), see Fig. 30
• to clean and sanitize pump filter (7), see Fig. 30
• clean front and back of evaporator using a brush with soft bristles
• clean and sanitize tilting panel (16) shown in Fig. 30

12 ELECTRONIC TIMER (OPTIONAL FUNCTION)

12.1 START

Once the appliance has been correctly connected to the electricity mains, water mains and water drain system, it can be started up as
follows:
a) turn on the water supply tap (8 in Fig. 4)
b) insert the plug (if any) in the socket and switch on the power supply by means of the relative switch fitted during the installation phase
(7 in Fig. 4)
Switch on appliance by pressing the luminous switch (1).
For appliances that are connected permanently to the electricity mains, turn on by means of the switch on the outside of the appliance,
fitted during the installation phase.