Installation; Technical Data (Fig. 1); Advice About Transportation; Unpacking - Bartscher 104.825A Mode D'emploi

Should you decide to scrap appliance, first disconnect the power
cable from the mains, and then cut the cable off.
In addition, proceed as follows:
• break off and remove the door in order to prevent the possible
danger of a child getting trapped inside
• do not allow the coolant gas and oil in the compressor to disperse
into the environment
• dispose of or recover the various materials according to the
provisions established by the current laws in force in your Country
This symbol means that this product should not be treated as a household waste. To prevent potential negative consequences for
the environment and health, be sure this product is correctly disposed of and recycled.
For information on the disposal and recycling of this product, contact your Distributor or the Waste Treatment Service.
This appliance does not contain coolant that damages the
ozone layer. This appliance contains fluorinated greenhouse
gases covered by the Kyoto Protocol. This product is
hermetically sealed.
The Manufacturer shall not be liable for any damage to the
environment, animals, persons or objects caused by incorrect

installation.

2 TECHNICAL DATA (Fig. 1)

The voltage and frequency are given on the data plate on the appliance. Refer to this data plate to check compliance.
Voltage (1), power (2), model (3), serial No. (4), Manufacturer (5).
The weighted equivalent continuous sound level A of this appliance is less than 70 dB(A). The measurements were made over an entire
production cycle, at a distance of 1 m from the surface of the appliance and at a height of 1.60 m from the floor.
The wiring diagram is stuck on the front counterpanel of the appliance.
In order to gain access thereto, unplug the appliance from the power source, loosen screws holding the front panel, and slide it away after
first opening the door.

3 ADVICE ABOUT TRANSPORTATION

The net weight and the weight including packaging of the appliance are given on the cover of this manual. Please refer to the instructions
on the packaging in order to correctly transport and lift the appliance.
To prevent the oil in the compressor from flowing back into the coolant circuit, always make sure that the appliance is kept upright during
transport, storage, and handling. Follow the instructions given on the packaging.

4 UNPACKING

E N
E N