After Operation - EUROM Alutherm Baseboard 1000 Mode D'emploi

Reset Wi-Fi connection
It is recommended to switch on the Bluetooth from your Smart Phone when making first time
connection with the heater, making first connection will be quicker and easier with Bluetooth.
1. Press and hold the MOD button. Existing connections will be deleted, the Wi-Fi symbol
will start blinking and a new connection will be made.
Switch off Wi-Fi connection
1. Press and hold the OFF button until a long beep sounds. The Wi-Fi is switched off and
the Wi-Fi symbol will disappear from the screen.
2. Press and hold the OFF button until a short beep sounds. The Wi-Fi is switched on and
the Wi-Fi symbol will appear on the screen.

After operation

CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
1. Make sure the ON/OFF switch is in the OFF position (Figure 12, pos. 1).
2. Disconnect the power plug from the power outlet (Figure 12).
3. Let the device cool down before touching it.
4. Wind the power cable.
5. Remove the batteries from the remote control (Figure 13).
35