EUROM Alutherm Baseboard 1000 Mode D'emploi page 30

Installation
WARNING
Do not put the power plug into the wall socket before the device is correctly
mounted or stands in the right place.
Do not use an extension cable; this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 2000 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
1. Make sure the device is correctly assembled.
2. Make sure the ON/OFF switch is in the OFF
position (Figure 12, pos. 1).
3. Place the power plug (Figure 12, pos. 2) into
an earthed wall socket that is easily
accessible. Use an earthed wall socket with a
minimum power of 2000 Watt.
Remote control
1. Remove the cover (Figure 13, pos. 1).
2. Remove the batteries (if present).
3. Insert two batteries (AAA 1.5 V) (Figure 13,
pos. 2) as indicated in the battery
compartment. Make sure to insert the
batteries correctly.
4. Replace the cover.
30
Figure 12
Figure 13