Program Function - EUROM Alutherm Baseboard 1000 Mode D'emploi

Program function

Use the plus and minus button to set the desired temperature.
Every 5 minutes the device will check the ambient temperature and adjust the heating
capacity. If the ambient temperature is:
•
more than 1°C below desired temperature, the device will increase capacity;
•
within 1°C below and 1°C above desired temperature, the device will use the same
capacity;
•
more than 1°C above desired temperature, the device will decrease capacity.
Weekly timer setting
CAUTION
If the heater is used with Wi-Fi connection, it is much easier to set the timer
settings with the Eurom Smart App.
1. Make sure the device is set to program function.
2. Press and hold the WEEK button until 01 appears on the screen.
3. Use the plus and minus button to choose the desired setting:
•
01 – one-off setting (must fall in the current week).
•
][ – every week setting.
4. Confirm with the SET button; ON appears blinking on the screen.
5. Use the plus and minus button to choose the desired anticipation setting:
•
ON – the heater will anticipate the temperature 20 minutes before it is set. If it needs to
be heated, the heater will heat with high capacity in order to heat the room to the
desired temperature by the activation time.
•
OFF – the heater will not anticipate the temperature and will turn on at set time.
6. Confirm with the SET button, 01 SET ON appears on the screen.
7. Use the plus and minus buttons to select:
•
the desired day, confirm with the SET button;
•
the desired temperature, confirm with the SET button;
•
the desired hours, confirm with the SET button;
•
the desired minutes, confirm with the SET button.
8. 01 SET OFF will appear on the screen; repeat step 7 to indicate the deactivation time.
9. 02 appears on the screen, there are two options:
•
Set next activation and deactivation times, repeat step 7 and 8 for every desired time.
Make sure the timer settings do not contradict each other: maximum 28 per week,
maximum 4 per day.
•
If you are done setting the activation and deactivation times, wait till screen returns to
standard settings.
10. The screen will show P and the device will automatically switch on and off at the set
time.
32