Location And Connection; Set-Up And Operation; Safety Features - EUROM EK2000 Manuel D'utilisation

The EK2000 control panel consists of two dials:
* The mode selector dial with 4 positions is located on the left.
From top to bottom:
* The continuously adjustable thermostat dial is located on the right.

Location and Connection


Remove all packaging material and keep out of reach of children. After removing packaging, check the
appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not
use the appliance, but contact your vendor for inspection or replacement.

Choose a suitable location for the heater, i.e. at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions). Always ensure that the heater has sufficient space at the
back to suck in air and at the front, to blow out hot air (1 metre).

Make sure the heater is always in an upright position on a solid, flat, horizontal and non-flammable surface.

Make sure the heater is switched off (switch to O position), then plug into a correctly functioning 230V-50Hz
socket. Only connect the heater to an earthed socket!

Set-up and Operation

If the heater is being used for the first time (or if you want to reset the desired temperature), turn the thermostat
dial to the maximum position (clockwise as far as it goes).
With the mode selector dial, adjust the heater to suit your preferences.
Once the temperature in the area being heated has reached the right level, slowly turn the thermostat dial
anticlockwise until you hear a soft click; leave the dial in that position. The heater will automatically maintain the
temperature at this level. It does this by switching the heating elements off and on when the temperature rises or
falls too much.
Note! After the thermostat has switched the heating elements off, the fan will keep turning. This means that the air
is constantly moved, allowing the heater to accurately detect if the area is cooling down.
The thermostat dial is continuously adjustable. A higher temperature is set by turning it clockwise; a lower
temperature by turning it anticlockwise.

Safety features

In case of internal overheating, the overheating safeguard will switch the heater off. If this occurs, immediately
turn the mode selector dial to O, unplug and allow heater to cool down for at least 10 minutes. In theory, the
heater can now be used as normal. There is, however, generally a reason for an appliance overheating. This may
be because the heater cannot adequately release its heat or take in fresh air (because the heater is covered, the
grills are blocked, the heater is placed too near a wall etcetera). Before using the heater again, therefore, remove
or adjust whatever caused the appliance to overheat. If you cannot find the cause and overheating recurs, stop
using the heater and contact your vendor or a certified electrician for inspection/repair. Overheating poses a
serious fire risk!
- O or off
- 650W power
- 1300W power
- 2000W power
11