Location And Connection; Set-Up And Operation - EUROM Safe-T-Fanheater 2000 Manuel D'utilisation

4. The device may only be opened and/or repaired by a competent
and qualified person. Do not carry our your own repairs as this
could be dangerous! Repairs carried out by unauthorised persons or
changes made to the device could damage the dust/waterproof
capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
1. Control dial
2. Thermostat dial
3. Pilot light
4. Fan grille

Location and connection

Remove all packaging material and keep out of reach of children. After

removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the

warnings mentioned earlier in this manual.
Fully extend the power cord and plug into a suitable 220-240V socket. To

prevent the circuit overloading, check that no other appliances are connected to
the same group.

Set-up and Operation

Turn the thermostat dial to maximum (clockwise as far as possible).

Switch the heater on by turning the control dial to one of the following three

positions:
29