Standby Mode; After Operation - EUROM Q-Tower 2000 RCD Mode D'emploi

Operation
WARNING
Before every use, make sure that:
•
•
•
CAUTION
When the device is turned on it can give off smoke and an odor. This is normal
and will disappear after a few minutes.
1. Press the ON/OFF switch (Figure 10, pos. 1).
2. The light indicator (Figure 10, pos. 3) starts to
flash.
3. Press the MODE button on the control panel
(Figure 10, pos. 2) or on the remote control
(Figure 5, pos. 2) until the desired setting is
reached:
•
low – green light;
•
medium – orange light;
•
high – red light.

Standby mode

1. Press the OFF button on the control panel (Figure 4, pos. 1) or on the remote control
(Figure 5, pos. 1).
2. The light indicator starts to flash (Figure 10, pos. 3).

After operation

CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
1. Make sure the ON/OFF switch is in the OFF position (Figure 8, pos. 1).
2. Disconnect the power plug from the power outlet.
3. Let the device cool down before touching it.
4. Wind the power cable.
5. Remove the batteries from the remote control.
you operate the device with dry hands;
the device is clean and dry;
the device is not damaged.
Figure 10
17