Set The Timer; Standby Mode; After Operation - EUROM 1500 RC Mode D'emploi

1. Set the ON/OFF switch to the ON position
(Figure 9, pos. 4).
2. The O light indicator lights up (Figure 11, pos.
2).
3. Press the ON/OFF button on the control
panel (Figure 11, pos. 3) or the remote
control (Figure 11, pos. 1).
4. The I light indicator lights up.
Set the LED light
1. Press the Light button on the remote control (Figure 5, pos. 3) repeatedly to choose the
desired light color:
•
red;
•
green;
•
blue
•
white;
•
off.

Set the timer

1. Use the Timer button on the control panel (Figure 4, pos . 6) or the remote control
(Figure 5, pos. 2) to start the count-down timer of:
•
1 hour, press 1 time. The 1H indicator lights up;
•
2 hours, press 2 times. The 2H indicator lights up;
•
3 hours, press 3 times. The 1H indicator and the 2H indicator light up;
•
4 hours, press 4 times. The 4H indicator lights up;
•
5 hours, press 5 times. The 1H indicator and the 4H indicator light up;
•
6 hours, press 6 times. The 2H indicator and the 4H indicator light up;
•
7 hours, press 7 times. The 1H indicator, the 2H indicator and the 4H indicator light up.

Standby mode

1. Press the ON/OFF button on the control panel (Figure 4, pos . 6) or on the remote
control (Figure 5, pos. 1).
2. The O light indicator lights up.

After operation

CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
Figure 11
19