After Operation - EUROM Rad 1000 Mode D'emploi

After operation

CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
1. Make sure the ON/OFF knob is in the OFF position (Figure 5, pos. 2).
2. Disconnect the power plug from the power outlet.
3. Let the device cool down before touching it.
4. Wind the power cable.
Maintenance
WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the
electric cable and/or electric plug is damaged, it should be replaced by the manufacturer or
its service employee or persons with similar qualifications to prevent risks.
Cleaning
WARNING
The device becomes very hot. Make sure the device is turned off, unplugged
and completely cooled down.
CAUTION
Do not use:
•
•
•
Prevent water from entering the device. Do not immerse any part of the device
in water or other liquids.
It is recommended to clean the device after each use and prior to storage.
1. Carefully vacuum the openings to remove dust and dirt.
2. Wipe the device with a damp, clean, soft, lint-free cloth or a soft brush.
3. Let the device dry completely prior to use and storage.
Disposal
At its end of life, discard the device according to the local laws and regulations, or deliver the
device to your supplier.
Attachments
The CE declaration can be found at the end of this manual.
16
scouring pads;
hard brushes;
flammable, aggressive or chemical cleaning products.