Russell Hobbs RHB-314 Manuel D'instructions page 11

Cleaning

Unplug the blender from the mains before cleaning and storing away.

Clean soon after use, to prevent residues settling inside the jug.

Remove the jug from the motor unit. Wash the jug, sieve, lid and cap in warm soapy
water, rinse well, then turn the jug upside down to drain and dry.

Keep hands out of the jug – BLADES ARE VERY SHARP.

If it is left for too long without cleaning and bits have glued themselves to the
inside of the jug, use a nylon brush to remove. If this does not work – crush a few
ice cubes in it.

It is not recommended to put the jug, sieve, lid or cap into the
dishwasher as this can affect the surface finishes. Do not
use harsh or abrasive cleaning agents or solvents.

Wipe the outside of the motor unit with a clean damp cloth.

Do not put the motor unit in water or any other liquid.
CONNECTING 3-PIN PLUG
Should the need arise to change the fitted/moulded plug, follow these
instructions:
Mains (AC) Operation
This unit is designed to operate on 230V current only. Connecting to other power
sources may damage the unit.
Connect three-pin plug as follows:
The wires in this mains lead are coloured in accordance with the following code:
Green/Yellow = Earth
If the supply cord is damaged, it must be replaced by the manufacturer or its service
agents in order to avoid a hazard. If service becomes necessary within the warranty
period, the appliance should be returned to an approved Tedelex Trading Pty Ltd
Service Centre. Servicing outside the warranty period is still available but this will be
chargeable.
Blue = Neutral Brown = Live