Publicité
Les langues disponibles
Les langues disponibles
Before Use
Before using your Blender for the first time wash the jug, lid and cap in warm soapy
water, rinse well and dry. NOTE: The blades are sharp-edged, handle with care.
Preparation
1. Position the motor unit on a dry, firm, level surface, close to a power socket and
out of reach of children.
2. Check that the control knob is set to OFF.
3. Insert the blade assembly into the base of the glass jar, and rotate it anti- clockwise until
it is locked.
4. Place the glass jar assembly on top of the base/motor of the blender.
Ensure that the jug is firmly in place by turning it in a clockwise direction to lock it. There
are 'Lock' and 'Unlock' markings on the unit. It is recommended that you place the jug
handle away from the controls situated at the front of the blender.
5. Plug the motor unit into the power socket
6. Put the ingredients into the jug. Do not fill it past the 1500 ml mark. If you do, the
contents may force the lid off when you start the motor.
Fitting the Lid
1. Always fit the lid to the jug before using it.
2. Press well on the lid until the flanges of embedding are well fixed in the jug.
3. Put the cap into the hole in the lid and press it down to fit properly.
4.
It is not a good idea to run the blender without the cap, especially if only solid
ingredients are used. They may be ejected through the hole when they hit the blades.
The Switch
Turn the control knob clockwise to the speed you require.
"OFF" - switch off, "1" – slow, "Max" - fast
Pulse Function
Pressing the pulse button will give you a short burst at maximum speed, regardless
of the current speed of the blades. The button is spring-loaded. When you stop
pressing, it will return to the speed the switch is pointing at.
Do not run the motor continuously for more than 3 minutes, or it may overheat. After 3
minutes switch off for at least 10 minutes to cool down. Do not use pulse function for
crushing ice.
Publicité
