Publicité
Les langues disponibles
Les langues disponibles
Exhaust Spark Arrestor
Clean carbon deposits from the spark arrester periodically while
the muffler and exhaust are at normal air temperature.
Ensure that the exhaust pipe and muffler are fully cooled
down before servicing the spark arrestor.
1� Remove the fasteners (1).
2� Tap the tailpipe lightly to loosen it and remove the spark
arrester from the muffler.
3� Use a wire brush to remove any carbon deposits from the
spark arrester portion of the tailpipe (2).
4� Insert the tailpipe into the muffler and align the bolt holes.
5� Install and torque the fasteners to 7.3 ft-lb. (10 N•m).
Battery
This vehicle is equipped with a 12 volt/30 Amp-hour, sealed low-
maintenance battery (A), which is located at the inner side of
the rear right fender. Therefore, it is not necessary to check the
electrolyte or add distilled water to the battery. If the battery seems
to have discharged, consult your dealer. Verify that the battery
connections are clean and secured during routine maintenance�
MAINTENANCE
CAUTION
A
151
1
2
Publicité
