CF MOTO UFORCE 1000 Guide De L'utilisateur page 142

1� Use a new drain bolt washer and tighten it to specified torque.
Drain bolt tightening torque: 22 ft-lb. (30 N·m)
2� Add recommended oil to specified level and then screw in the
oil dipstick�
Oil capacity with oil filter replacement: 84.5 oz. (2.5 L)
3� Start the engine and allow it to warm up for a few minutes.
Check for oil leakage when the engine is warm. Stop the
engine immediately if oil leaks are present.
4� Stop the engine and check the engine level. Revise if
necessary�
MAINTENANCE
NOTE
NOTE
138
3
3 Oil filter 4
4
O-ring