Publicité
Les langues disponibles
Les langues disponibles
Spark Plug Removal and Inspection
1� Tilt the cargo box.
2� Clean any dirt or debris from the spark plug and cylinder area.
3� Remove the spark plug cap�
4� Use the spark plug socket and wrench from the tool kit to
remove the spark plug�
5� Check the spark plug gap (A) using a thickness gauge. Adjust
the gap if necessary.
NOTE:
Specified spark plug: DCPR8E (NGK)
Spark plug gap: .031 in ~ .035 in (0.8 mm~0.9 mm)
6� Clean the gasket surface. Wipe off any grime from the threads.
7� Install spark plug and tighten to specified torque.
NOTE:
Spark plug torque: 14.8 ft-lb. (20 N•m)� If a torque wrench is not
available when you are installing a spark plug, a good estimation
of the correct torque is that, tight the spark plug by finger first, then
use tool to tight from 1/4 to 1/2 position.
8� Install the spark plug cap�
9� Install the cargo box access panel. Torque the fasteners to 7.3
ft-lb. (10 N•m)�
MAINTENANCE
149
Publicité
