Publicité
Les langues disponibles
Les langues disponibles
Change the Coolant
After running the engine, never remove the radiator cap immediately. Wait for the engine to cool
down before removing the radiator cap. Hot coolant can cause serious burns.
1� Place the vehicle on a level surface.
2� Remove the front access cover.
3� Remove the radiator cap (1) �
4� Remove the coolant reservoir cap (2)�
5� Place a container under the engine, and then remove the
coolant drain bolt (3).
6� Disconnect the hose from the coolant reservoir, and drain the
coolant into a container�
7� After draining the system, thoroughly flush the system with
clean tap water� Allow the water to drain completely�
8� Replace the coolant drain bolt washer if it is damaged, then
install and tighten the coolant drain bolt, but do not torque to
specification.
9� Reinstall the coolant reservoir hose�
10� Fill the recommended coolant into the radiator until it is full.
NOTE:
When filling coolant, at the same time loosen the coolant drain
bolt to draw out potential air bubbles inside the coolant hose until
coolant flows out, then tighten the drain bolt to 7.3 ft-lb. (10 N•m).
11� Install the radiator cap�
MAINTENANCE
CAUTION
146
1 Radiator cap
2 Reservoir cap
2
1
Publicité
